Welcome to our store!
Welcome to our store!
Customer Support [email protected]

POLYUTHERANE GLUE 250 cc Dual element polyurethane glue for synthetic materials (PVC, PU, etc.)

$24.99 $14.99

POLYUTHERANE GLUE 250 ccDual element polyurethane glue for synthetic materials (PVC, PU, etc.)It has been specially developed for plastics (PVC, polyurethane, etc.), rubbers, leather, etc.It is used for inflatable boats made repair PVC (Strongan, Tersilon,


SKU: I7216070860 Category:

POLYUTHERANE GLUE 250 ccDual element polyurethane glue for synthetic materials (PVC, PU, etc.)

It has been specially developed for plastics (PVC, polyurethane, etc.), rubbers, leather, etc.

It is used for inflatable boats made repair PVC (Strongan, Tersilon, etc).

It treats well with heat and is very resistant to hydrolysis.

SURFACE PREPARATION:

  • The surfaces must be clean, dry and degreased.
  • Allow to dry.
  • APPLICATION This glue is used with the hardener in an amount of 4% (or 40 ml per liter).
  • Mix 4% hardener with the desired amount of glue.
  • Mix to an even consistency.
  • Allow to dry for 5 to 10 minutes.
  • When the glue starts to dry, the second layer of glue.
  • Allow to dry for 10 minutes.
  • Then firmly press both sides.
  • Bonding is immediate.
  • The full effect is achieved after 48 hours.
  • This process is carried out at a temperature of 20 C and ideally less than 65% relative humidity

Base Product: polyurethane in a solvent system

Color: Colorless, translucent

Viscosity: 4000 mPa.s A

Density: 0.86 g / cm3 + – 0.02 conventional dry (EN827): 19% + – 3%

Open time limit at 20 C: 10 minutes

Temperature resistance of the joints: – 30 to 100 C with 4% hardener

Final setting at 20 C: 48 h

Pot life: About 12 hours with 4% hardener

Flash point: <= 21 C

Hardener Base Product: polyisocyanates in solution in a chlorinated solvent system Color: Brown, yellow

Viscosity: very smooth

Density: 0.96 + – 0 , 02 conventional dry (EN827) 27 + – 2%

NCO content: About 8%

Flash point: <= 21 C

If you have any concerns regarding the suitability of the item please ask before purchase.

If the part looks the same as yours is not always the right one for your outboards so please double-check.

Marine grade quality aftermarket part.

OEM part number used for reference only.

The item is completely compatible and interchangeable with the OEM.

Our aftermarket parts are either produced in the European Union or imported in Europe from a major distributor. Our parts not only meet the required standards for marine engines but also comply with European laws and regulation of quality.

Reviews

There are no reviews yet.

Be the first to review “POLYUTHERANE GLUE 250 cc Dual element polyurethane glue for synthetic materials (PVC, PU, etc.)”

Your email address will not be published. Required fields are marked *

Related products